Available tabletop dimensions: 120x70 (cm), 120x80 (cm), 140x70 (cm), 140x80 (cm), 160x70 (cm), 160x80 (cm).

(Other dimensions are possible, we also produce according to individual orders).

Available frame colors: silver / gray (RAL 9006) / white (RAL 9016) / black (RAL 9005).

Column Type: Three-segment rectangular columns, the largest at the bottom.

Engine type: Two engines (Bosch, Germany).

Adjustable height (without table top): 617 - 1217 mm.

Recommended table top length: from 1100 to 2100 mm.

Recommended table top depth: 700 to 900 mm.

Load: up to 120 kg.

Obstacle detection function: yes.

Noise level: <43dB Speed: up to 30 mm / sec.

Memory: YES

The feet of all systems are 730 mm long with adjustable feet.

The frame of all systems for mounting the worktop is adjustable in length.

All systems are packed in one box, you will find: adjustable frame, two columns, two feet, power cable, control panel, fasteners.

By additional agreement, we can install electrically operated table frames on your existing table tops.

We produce non-standard furniture according to individual orders.

This handset has an editable memory for high and low (stand and sit) positions.

It could also be used to avoid collision with i.e. a cabinet or pedestal.

When the memory position is set the desk will stop when the memory position is reached. to drive the desk outside the memory position press the up or down button for a minimum of 5 seconds.

How to set memory/end positions:

1. Drive your desk to the level you want it.

2. Press both buttons 3 times (0,5-1 second between each pressing).

3. Then press "up" or "down" to set the position (0,5-1 second).

4. Do the same procedure for your second store.

To clear memory positions perform a reset as described in the next step.

If a motor or other electronic has been disconnected from the column, during or after the assembly, a reset (homing) cycle MUST be performed.

A reset cycle should be made with an evenly distributed weight of approx. 45 kg applied on the desk.

Perform a reset by: Simultaneously press the up and down buttons for a minimum of 8 seconds.

Press and hold the down button and the desk will slowly move to the lowest point possible.